Hay Mover

When we went to big bales, we worried about moving them around the property. The first year wasn’t bad since we had 8 delivered at a time, and just dropped them in the barn from the trucks and fed off them. However this year, with a hay shortage, we decided we needed more and had 24 or so delivered in the fall. A friend has a similar, but slightly smaller, tractor, and he built a set of pallet forks for his tractor.

We were hoping he would help us, but he ended up getting hurt, and with hay getting in short supply in the barn, we decided to just order some. A little bit of trouble since the original forks we planned on were not being made, but we decided to move to a skid steer adapter, and then add pallet forks, or other attachments to that.

I’d been meaning to go get them, but too busy. However today, despite waking up a little late, I packed up Kendall after feeding horses and raced up there. We were pushing 82 in a 75 most of the way, arriving at 11:58 (they closed at 12). They’re in the country, and good neighbors, and a guy stuck around to help me load my stuff, and take the bucket off. They’re going to adapt the bucket to work with the skid steer, and so  I left it, bringing back the load above. Pallet forks on top, and the skid steer adapter on the bottom.

We got home, and my first step was to remove the old bucket quick attach frame. Not sure what we’ll do with that, but I pulled it off.

It’s four bolts held in with pins and they were fairly easy to remove. A little pounding, but it worked fine. However it’s a pain and definitely not what I want to be doing to switch from the forks to the bucket.

I then lifted and grunted the adapter near and managed to get it attached. The first pin is in above, and surprisingly it wasn’t too bad to get them all in. However that thing is a 100 lbs of solid metal and not easy to move. Taking this one and off would not be fun.

 

Once it was on, it looked pretty good. I had to lift the tractor and then adjust it slightly to get the pins in, and then I added the forks.

We didn’t move hay, but we did test them out and they worked pretty good.